A ball is rolling without slipping in a spiral path down the inner surface of a hollow fixed cone whose axis is vertical. The work done by the inner surface of the cone on the ball is

As shown in the figure, $S$ is the point on a uniform disc is rolling with a uniform angular velocity on a fixed rough horizontal surface. The only forces acting on the disc are its weight and contact forces exerted by the horizontal surface. Which is the best graph that represents the magnitude of the acceleration of point $S$ on a uniform disc as a function of time?

A disc of mass $m$ and radius $r$ is placed on a rough horizontal surface. A cue of mass $m$ hits the disc at a height $r/2$ from the axis passing through centre and parallel to the surface as shown. The cue stops and falls down after the impact. The disc starts its motion as:

A cylinder moves with linear velocity $v$ to the right and angular velocity ω in the anticlockwise direction. The cylinder was initially at rest. The cylinder does not perform pure rolling and stops after some time. What will be the radius of the cylinder?

A solid sphere is set into rotation at an angular velocity ${\text{ω}}_0$ and it is then, placed on a rough horizontal surface. The ratio of distances covered by rotational and translational motions up to the start of the pure rolling is (assume uniformly accelerated motion up to start of pure rolling):

A sphere of mass $m$ is given some angular velocity about a horizontal axis through its center and gently placed on a plank of mass $m.$ The coefficient of friction between the two is $\mu$. The plank rests on a smooth horizontal surface. The initial acceleration of the center of sphere relative to the plank will be:

A cylinder $A$ rolls without slipping on a plank $B$. The velocities of center of the cylinder and that of the plank are $4 \mathrm{m} {\mathrm{s}}^{-1}$ and $2 \mathrm{m} {\mathrm{s}}^{-1}$ respectively in the same direction with respect to the ground. The angular velocity of the cylinder, if its radius is$1 \mathrm{m}$ is

A rigid body undergoing uniform pure rolling encounters horizontal tracks $AB$ and $BC$ as shown $AB$ is a smooth layer of ice and $BC$ is a rough surface with $\mu =1.$ Both $AB$ and $BC$ are rigid tracks. Which of the following statements are correct?

$\left(1\right)$ The body will slow down over $BC$.

$\left(2\right)$ The body will start slipping on $AB$.

$\left(3\right)$ The body remains in pure rolling over the whole stretch $AC$.

$\left(4\right)$ The angular velocity of the body remains constant over the whole stretch $AC$.

A spool is resting on a horizontal rough table. Forces $F_1, F_2$ and $F_3$ are applied separately as shown. $F_1, F_2, F_3$ all are applied tangentially to the inner circle. $F_1$ is horizontal, $F_3$ is vertical and $F_2$ is passing through the point of contact of spool and table. The correct statement is (assuming that there is no sliding)?