MEDIUM
Earn 100

The Poisson's ratio of the material of a wire whose volume remains constant under an external normal stress is _____

50% studentsanswered this correctly

Important Questions on Properties of Solid and Liquid

MEDIUM
In an experiment, brass and steel wires of length 1 m each with areas of cross section 1 mm2 are used. The wires are connected in series and one end of the combined wire is connected to a rigid support and other end is subjected to elongation. The stress required to produce a net elongation of 0.2 mm is,
[Given, the Young's Modulus for steel and brass are, respectively, 120×109 N/m2 and 60×109 N/m2 ]
MEDIUM
An elevator of mass m  is connected to a rope which pulls the elevator up with a maximum acceleration equal to a . If the maximum bearable tension in the rope is T , then for a safe journey the minimum diameter of the rope is [ g = acceleration due to gravity]
MEDIUM
A body of mass m=10 kg is attached to one end of a wire of length 0.3 m. What is the maximum angular speed (in rad s-1) with which it can be rotated about its other end in a space station without breaking the wire?
[Breaking stress of wire σ=4.8×107 N m-2 and area of cross-section of the wire=10-2 cm2]
EASY
A and B are two wires. The radius of A is twice that of B. They are stretched by the same load. Then the stress on B is
EASY
A uniform metallic wire is elongated by 0.04 m when subjected to a linear force F. The elongation, if its length and diameter is doubled and subjected to the same force will be _________ cm.
EASY
A cube of metal is subjected to a hydrostatic pressure 4 GPa. The percentage change in the length of the side of the cube is close to : (Given bulk modulus of metal, B=8×1010 Pa)
EASY
A steel wire having a radius of 2.0 mm , carrying a load of 4 kg, is hanging from a ceiling. Given that g=3.1π s-2, what will be the tensile stress that would be developed in the wire?
EASY
If a tensile force is suddenly removed from a wire then its temperature will
MEDIUM
A rubber (eraser) 3cm×1cm×8cm is clamped at one end with 8cm edge vertical. A horizontal force of 2.4N is applied at the free end (the top face). If the shear modulus of the rubber is 1.6×105Nm2, then the horizontal displacement of the top face will be
MEDIUM
A wire of length 1 m and radius 2 mm is vertically clamped. The lower end is twisted through an angle of 45°. The angle of shear is _____
HARD

A mild steel wire of length 2 L and cross-sectional area A is stretched, well with in the elastic limit, horizontally between two pillars as shown in figure. A mass m is suspended from the mid-point of the wire. Strain in the wire is

Question Image

EASY
The speed of the water in a river is V near the surface. If the coefficient of viscosity of water is η and the depth of the river is H, then the shearing stress between the horizontal layers of water is
HARD
A lift is tied with thick iron ropes having mass M. The maximum acceleration of the lift is ‘a m s-2 and maximum safe stress is S N m-2. The minimum diameter of the rope is
EASY
Two wires A and B are stretched by the same load. If the area of cross-section of wire 'A' is double that of  'B', then the stress on 'B' is
MEDIUM

Two blocks of masses 3 kg and 5 kg are connected by a metal wire going over a smooth pulley. The breaking stress of the metal is 24π×102 N m-2. What is the minimum radius of the wire ?
( take g=10 m s-2

Question Image

MEDIUM

The two blocks P and Q are connected by a metal wire with breaking stress 109 N m-2 through a frictionless pulley. The minimum radius of the wire for it not to break is (consider g=10 m s-2)

Question Image

EASY
A man grows into a giant such that his linear dimensions increase by a factor of 9. Assuming that his density remains same, the stress in the leg will change by a factor of:
EASY
The length of metallic wire is l1 when tension in it is T1. It is l2 when the tension is T2. The original length of the wire will be :
MEDIUM
The length of a metal wire is l1 when the tension in it is T1 and is l2 when the tension is T2. The natural length of the wire is,