Mechanics

Electric brakes are commonly used on-

The angle between the base and the slop of the cone formed on a free vertical fall of the granular material to a horizontal plane

Which one of the following pairs is Not correctly matched ?

The impact and shear resistance are important for

The complementary shear stresses of intensity are induced at a point in the material as shown in the figure. Which one of the following is the correct set of orientations bf principal planes with respect to AB ?

Which of the following are the necessary requirements of an oscillator?

To carry a large axial load in a flat collar bearing a number of collars is provided to _____.

Given, the tension in tight side $T1$ = $80 N$, the tension in slack side $T2$ = $40 N$  and the angle of lap $A$ = ${45}^{°}$. Find the coefficient of friction µ?

Balance of a rigid rotor can be achieved by appropriately placing balancing weights in

Wind turbulence is greater on

For a perfect incompressible liquid flowing in a continuous stream, the total energy of a particle remains the same, while the particle moves from one point to another is called:

The hand brake usually operates on-Enable GingerCannot connect to Ginger Check your internet connection
or reload the browserDisable in this text fieldRephraseRephrase current sentenceEdit in Ginger×

The measure of fluids resistance to sheer or angular deformation:

A transmission line has a reactance of 1 Pu is operating at V_s = V_r = 1 Pu. The generator is connected at source end which is delivering 0.5 Pu of active power. Find the load angle?

Open centre system maintains a

Newton's First Law of Motion is sometimes called the "Law of Inertia". What is "inertia"?

A clutch is usually designed to transmit maximum torque which is _____.

Which one of the following figures represents the correct shear force diagram for the loaded beam shown in the given figure I ?

A liquid mass readjusts itself and undergoes a rigid body type of motion when it is subjected to a-

Which of the following devices are used for motion measurements, no fixed reference is available.